If there is no gateway, enter the IP address of your computer as a gateway address.Īssume that you want to reach to the computer having the IP address “192.168.100.101”. If there is a server or a router which acts as a gateway, enter the address of the server or the router. Set the default gateway to the host on which you are setting up the network interface. You can find out the MAC address on a status sheet.įirst, you need to check that the computer can reach to other computer in the same segment, as follows: The MAC (Ethernet hardware) address of the network interface. If you are the network administrator, choose an address within your subnet which does not conflict with any other device. Ask your network administrator for an IP address which does not cause conflicts with any other device on the network. Make sure the network interface and the computer are in the same segment.īefore you start, you need the following information:Ī valid IP address for the network interface. If this function is disabled, you cannot set the IP address using the arp/ping command. Make sure that the Set using PING function is enabled on the TCP/IP menu in EpsonNet Config. You can also use these commands with Windows Me/98/XP/2000/NT 4.0, if you have correctly installed TCP/IP networking on these systems. If you are using UNIX or OS/2, you need to use the arp and ping command to set the IP address of the network interface. Setting an IP Address Using the arp/ping Command

Using arp command to find mac address